ElektroNorm Inspecties & Services
Home About us
Our services
How we work
Preparation
Areas
Contact Request a quote

How thermography works on an electrical installation

TechniqueReading time: 4 minutesUpdated: September 2026
Google rating: 5,0 out of 10 reviews★★★★★Rated by our clients

A thermal image looks impressive, but the value lies in the interpretation. Here is how we use thermography during an inspection, and what the result gives you.

Heat reveals a problem before it exists

Every poor electrical connection has a higher contact resistance, and that converts current into heat. A bolt half a turn loose, oxidation on a terminal, a conductor just too thin for what passes through it: you see nothing, but a thermal camera does.

That is why thermography is a mandatory part of the Scope 10 inspection within NTA 8220. It is the only method that reveals hidden heat development without switching the installation off.

The measurement must be under load

No current, no heat, so no usable thermal image. A connection that only warms up at sixty percent load stays invisible on a quiet morning. We therefore match the timing to your operation.

During assessment we correct for the actual load at that moment, the ambient temperature and the material. A reading of 45 degrees means nothing by itself; what matters is the difference from comparable points in the same board.

What a thermal image cannot do

To be fair: thermography is not a cure all. These limitations come with it.

  • Closed panels: what sits behind a closed door can only be measured if the panel can be opened
  • Unloaded sections: a circuit not in use at that moment shows nothing
  • Early insulation faults often generate no measurable heat; that is what electrical measurements are for
  • Reflective surfaces can distort a reading, which takes expertise to judge

What you receive

If we find a deviation you receive the thermal image alongside a reference photograph, the measured temperatures, the load at that moment and a classification of severity. Your electrician then knows exactly what to do and where to be.

Apart from the Scope 10 inspection we also carry out thermography as a separate check, for instance halfway through your inspection interval.

In practice this subject belongs with our SCIOS Scope 8 inspection en SCIOS Scope 10 inspection. There you can read how we work and what exactly is checked, or you can request a quote without obligation aan.

Further reading: what happens if your installation fails?, re-inspection after repairs, registration in the SCIOS portal.

Tip from the inspector

If you are unsure which inspection you need, send us the passage from your policy that mentions electrical work or inspection. We read those daily and can see within minutes what your situation requires.

Frequently asked questions

Must the installation be switched off during thermography?

No, quite the opposite. The installation must be running, otherwise there is no heat development to measure.

How warm is too warm?

That depends on load, environment and material. We work with temperature differences relative to comparable points, and with the classifications from the standard.

Can I walk around with a thermal camera myself?

You would see something, but the value lies in correct interpretation and in measuring under the right conditions. A valid report also requires a certified inspector.

Prefer personal advice?

Call us or ask your question through the form. We are happy to think along about what your situation needs.

Get in touch Request a quote

Want your installation inspected by a SCIOS certified body?

Request a quote without obligation, or call us to discuss the scope of the inspection.

Request a quote More information
Make a request