ElektroNorm Inspecties & Services
Home About us
Our services
How we work
Preparation
Areas
Contact Request a quote

Scope 12: why solar panels are inspected separately

SolarReading time: 4 minutesUpdated: September 2026
Google rating: 5,0 out of 10 reviews★★★★★Rated by our clients

Solar panels on a commercial roof are financially attractive and technically a world apart. That is precisely why they fall outside the regular inspection and have a scope of their own.

Direct current behaves differently

The section between the panels and the inverter runs on direct current, which is a different animal from the alternating current in your building. An arc in an alternating current circuit extinguishes itself at every zero crossing; in a direct current chain there is no zero crossing, so an arc keeps burning as long as the sun shines.

On top of that you cannot simply make the installation dead. As long as light falls on the panels, voltage is present. That makes Scope 12 an inspection with its own risks and its own measuring methods.

Where most defects are found

Our inspections keep producing the same picture. These are the points that most often go wrong.

  • Cross mating: connectors of different brands clicked together, causing arcing in rain and heat
  • Cabling lying loose across the roof or chafing over sharp edges
  • Ballast or mounting not applied according to the installation plan
  • Missing marking that a PV system is present, leaving the fire service unaware
  • Insulation faults in the DC chain that only appear when damp

What we measure

We inspect the entire chain: the mechanical structure on the roof, the cabling and cable management, the connectors, the inverters and the connection in your distribution board. For the electrical measurements we use a Metrel MI 3116 PV tester, built specifically for direct current chains.

Where possible we combine this with thermography, because a poor connector also reveals itself through its temperature.

Combine it with your other inspection

If you already have a Scope 10 inspection scheduled, have the PV inspection done during the same visit. The inspector is already there, the distribution board is already open, and you have one appointment instead of two.

In practice this subject belongs with our SCIOS Scope 10 inspection en SCIOS Scope 12 inspection. There you can read how we work and what exactly is checked, or you can request a quote without obligation aan.

Further reading: thermography in practice, scope 12 and the fire risk of solar panels, inspecting EV charging points.

Tip from the inspector

If you are unsure which inspection you need, send us the passage from your policy that mentions electrical work or inspection. We read those daily and can see within minutes what your situation requires.

Frequently asked questions

Are solar panels not covered by the regular inspection?

No. Scope 8 and Scope 10 cover the installation inside your building. The PV installation has its own scope because the direct current chain carries different risks and requires different methods.

Must the panels be switched off during the inspection?

For part of the measurements we shut down the inverter, but the panels remain live as long as light falls on them. That is exactly why this work requires expertise.

How often must a PV installation be inspected?

Usually every five years, sometimes every three. Your insurer names the interval; for larger installations three years is more common.

Prefer personal advice?

Call us or ask your question through the form. We are happy to think along about what your situation needs.

Get in touch Request a quote

Want your installation inspected by a SCIOS certified body?

Request a quote without obligation, or call us to discuss the scope of the inspection.

Request a quote More information
Make a request