ElektroNorm Inspecties & Services
Home About us
Our services
How we work
Preparation
Areas
Contact Request a quote

Inspecting EV charging points: what an inspector checks

TechniqueReading time: 4 minutesUpdated: September 2026
Google rating: 5,0 out of 10 reviews★★★★★Rated by our clients

Charging points have become standard at commercial premises in just a few years. They draw high power, often stand outdoors and are used daily. Reasons enough to look at them separately during an inspection.

Continuous power, for hours

A charging point does not draw current briefly like most equipment, but for hours on end at a high and constant level. That is precisely the load under which a mediocre connection heats up. During an inspection of charging infrastructure we therefore pay close attention to the supply, the protection and the connections.

If charging points are added, the question also arises whether your connection and distribution board can handle it, and whether the load management does what it should.

Outdoor placement and daily use

A charging point stands in all weathers and is operated by everyone. That places demands on the degree of protection, the mounting, the cable entry and protection against vehicle impact.

The charging cables themselves are work equipment: damaged cables and connectors are something we regularly encounter, certainly with intensive use by multiple drivers.

What we look at specifically

These points are on our standard list for charging infrastructure.

  • The correct residual current protection, including detection of direct current components
  • Cable sizing and protection of the supply
  • Earthing and the quality of the earth electrode resistance
  • The condition of the connections under load
  • IP rating, mechanical protection and mounting of the unit itself

Commission first when extending

If a charging point is added, that is an extension of your installation and requires a NEN 1010 commissioning inspection. After that it simply forms part of your periodic inspection.

We carry that out as a separate assignment or combine it with your existing inspection, which is usually easiest for scheduling.

In practice this subject belongs with our SCIOS Scope 10 inspection en SCIOS Scope 12 inspection. There you can read how we work and what exactly is checked, or you can request a quote without obligation aan.

Further reading: SCIOS Scope 10 inspection in Nijmegen, SCIOS Scope 10 inspection in Zevenaar, SCIOS Scope 10 inspection in Apeldoorn.

Tip from the inspector

If you are unsure which inspection you need, send us the passage from your policy that mentions electrical work or inspection. We read those daily and can see within minutes what your situation requires.

Frequently asked questions

Do charging points fall under Scope 8 or Scope 10?

They belong to your electrical installation and are covered within both scopes. New or extended charging infrastructure adds a NEN 1010 commissioning inspection.

Must charging cables be inspected separately?

Yes, they are work equipment. With intensive use that is far from a superfluous check.

Can my connection handle more charging points?

That depends on your connection capacity and the distribution. We see it during the inspection and flag it when the margin gets tight.

Prefer personal advice?

Call us or ask your question through the form. We are happy to think along about what your situation needs.

Get in touch Request a quote

Want your installation inspected by a SCIOS certified body?

Request a quote without obligation, or call us to discuss the scope of the inspection.

Request a quote More information
Make a request